Hyundai Santa Fe Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
I was removing the tail light housing on my wife's car I broke the plastic retaining pin held on with two screws. The dealer said there is no part number for the retainer and I have to buy the entire housing. Does anyone know a part number?
 

·
Registered
Joined
·
3 Posts
I'm sure that's not available your best bet is find a wrecking yard that you can get part from they may sell you just the clip, worst case if you have to order new one try this website I get all my o.e. parts here and their cheaper then dealers for sure. hyundaipartsdeal.com but make sure to try wrecking yards first seams like you should be able to find one.
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #3 ·
Thanks, I used JB weld and its holding so far. I've been thinking about going to a pick a parts.

When removing the tail light after removing the two screws in the back. Pull the housing out to the side and never pull back toward the back of the car.
 
1 - 3 of 3 Posts
Top